1, product introduction
This type functional chaff cutter wears a flywheel. When the spindle speed reaches 2600 revolutions
per minute, the flywheel can store a large enough energy group.
Small power (such as the single-phase 3 kW motor) to complete the
normal work of straw cutting and grinding.
Second, usage and characteristics
This series of cutter machine can be processed forage straw, cotton stalk, wheat straw, beans,
orange and all kinds of grain. This chaff cutter has chopping,
kneading and crushing characteristics as one of the new high spray
in the hay when material can be thrown 2-5 meters away, improve the
old models require frequent discharge faults, is an ideal equipment
for small and medium-sized family farms and raising chickens,
ducks, pigs, cattle, sheep and poultry. Food. With small powerl,
high yield, simple structure, convenient operation, one person can
operate a wide range of raw materials, processing, not by the
Third, structure and working principle
1. The machine consists of the upper shell, the lower shell, the
outlet, the feed hopper, the angle steel frame, the hammer and the
2. When smashing, the size of the crushing material is controlled
by the size of the sieve hole, and the different screen mesh can be
3, when cutting the grass, to screen out.
1. The machine should be installed on a flat and sturdy site.
2, equipped with a good motor according to the requirements.
3, install the belt before the inspection index is consistent with
the direction of cutting power and cutting hay cutter, the
confirmation of adjustment after the installation of belt, and the
belt tightness appropriate.
4, before the start of the moving knife to cut grass gap inspection
and adjustment, adjust the gap between the control below 0.8 mm
without bump as the standard, and then the locking bolt.
5, adjust the parts normally, confirm the correct operation, then
connect the power to trial run, check whether there is any
loosening of the fastener connections at each part, whether there
are abnormal sounds in the rotating parts.
4. Safe operation and maintenance
1, must read instructions before starting, and according to the
fixed adjustment and maintenance, the operator must grasp the
structure and function of the machine requirements.
2, the supporting power must conform to the requirements, not to
improve the spindle speed.
3, check whether the operation boot direction and cutting
direction, otherwise do not start.
4, need not be mixed with metal and stone hard cutting materials,
otherwise it will cause damage to the machine.
5. After a few hours of the machine, it is necessary to observe
whether the components are loose or not, and the bearings must be
regularly injected with butter.
6, when feeding the material, the operator's hands must not be near
the blade, so as to avoid adult injury accidents. The feed should
be evenly distributed, not too fast or too slow.
7, drunk, sick, or excessive fatigue, no gloves, retarded, young
people under 18 years of age, 60 years old, did not grasp the hay
cutter using the rules of the separate operation.
8, in the work, such as the discovery of clogging grass and other
faults, the power should be cut off immediately, and the operation
will be carried out after the troubleshooting, and the machine
should be strictly prohibited.
9, non workers, unfamiliar with the performance of the mechanism of
the machine shall not open the machine casually.
10. When the machine is not used for a long time, it should be
stored in the room or in the shed in order to prevent the corrosion
of the machine.
working video: https://youtu.be/KVXtSsO_f1M
If you have interest, just feel free to send inquiry, talk with us
online, or call us directly. +8613683823082 Mr Liu, and If you use
whatsap, it will be ncie. add this No. We will get back to you at